|
D-Link 804 configuration for PPG
The D-Link 804 can be easily
configured to support your Personal
Phone Gateway (PPG).
To configure your D-Link 804 to
support your PPG, please follow the
directions below.
couple of clicks.
Step 1:
Before installation of your Personal
Phone Gateway (PPG)
Your D-Link 804 is sharing your
Internet connection to all of your
PCs.
Step 2:
After installation of your Personal
Phone Gateway (PPG).
Simply install the PPG application on
one of your PCs and drop in the PPG
PCI card.
You can continue to use the PC
normally as your PPG will have no
effect on the normal operation of your
PC.
The PC that has your PPG installed
needs to have port 1720 (also known as
NetMeeting) and port 6667 (also known
as IRC server) directed to it from
your Internet sharing hardware or
software (HomePortal, router or ICS).
Step 3:
D-Link configuration for your Personal
Phone Gateway (PPG).
The configuration update of your
D-Link 804 is simple - only needs a
couple of clicks.
Enter
http://192.168.0.1/adv_serversettings.htm
in your browser
Set the DMZ to 192.168.0.0
Enter the Internal I.P. address of the
PC with the Personal Phone Gateway
card installed (in this case the
internal IP is 192.168.0.60).
Enter 1720 ~ 1720 as the first Service
Port Range
Enter 6667 ~ 6667 as the second
Service Port Range
Notes
The PC running Personal Phone Gateway
can be used just like any other PC on
your network.
Ensure that your D-Link 804 is running
firmware 4.68 or later, you can
download the latest firmware from;
ftp://ftp.dlink.com/Gateway/di804/
Next . . .
You are now all set to place calls
through your Personal Phone Gateway
(PPG).
|
